Hello all, I have a burning question in regards to network and the setup of one. Well I have had this setup for the longest time and its very simple. Its just a 4-Port Router and 3 computer are on it with Internet Access. Now I am introducing a Wireless Router (LinkSys WRT54G) into the mix. So i have it connected to the Router that was on the existing network. Well since the Wireless Router has a 4-Port Router/Switch and on one of those ports is a computer hooked up to it but the problem is how do I go about accessing that computer that is wired and I should have mentioned that this is a two part question because the Wireless part is not working.
I am not quite sure what is going on with the Wireless end but everytime I attempt to have a computer access the Wireless end of the Router it does not assign any IP's to the Wireless Clients. It always gives me a Limited or No Connectivity Error message. I have attempted the whole SP2 fix on it with the RegEdit file and have also gotten the patch from M$ and with no avail it did nothing to soultionize my problem.
If anyone has any insight that they can share with me or any suggestions, help, or advice i would greatly appreciate it. Thanks
I am not quite sure what is going on with the Wireless end but everytime I attempt to have a computer access the Wireless end of the Router it does not assign any IP's to the Wireless Clients. It always gives me a Limited or No Connectivity Error message. I have attempted the whole SP2 fix on it with the RegEdit file and have also gotten the patch from M$ and with no avail it did nothing to soultionize my problem.
If anyone has any insight that they can share with me or any suggestions, help, or advice i would greatly appreciate it. Thanks