you think one of those programs could help me? i tried to download them but i can't find the first one and the second isn't working so i dunno, but as i said earlier, like the settings with the jumpers on my mobo don't make any sense, that is if i look at the map packard bell send me:
Four 2-pin jumpers to set bus speed.
Bus Speed JP5 JP6 JP7 JP8
66 OFF ON ON ON
75 OFF ON ON OFF
83 OFF ON OFF ON
90 ON ON ON ON
95 OFF ON OFF OFF
100 OFF OFF ON ON <= this is my setting right now
and as for the multiplier:
Multiplier JP2 JP3 JP4
×1.5/×3.5 OFF OFF OFF
×2/×6 ON OFF OFF
×2.5 ON ON OFF
×3 OFF ON OFF
×4 ON ON ON <= this was the original setting, ran @ 450
×4.5 ON OFF ON <= changed to this, ran @ 400 mhz
×5 OFF ON ON <= now it's on this one, @ 500 mhz
×5.5 OFF OFF ON
So do you think that maybe the information about the jumpercodes given to me by packard bell are incorrect and that if i like used the settings from X 2.5 it actually will run faster as where it is on now, because @ 4.5 the speed fell to 400 mhz, and that @ x4 the speed is 450 mhz, right now the only setting that makes sense is the one where it is on now, x5 @ 500 mhz, so do you think if i tried all the other settings they would give different results?
And does anyone have any other opinions about my vidcard post earlier this thread?
Thanks in advance!