• This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn more.

how to raid

#2
In short:

1. Connect the drives to the RAID channel(s).
2. On bootup, enter the RAID BIOS.
3. Set up the array as RAID 0 (striped) (the "how" may vary)
4. Reboot and start Windows.
5. Partition, format and assign a drive letter in Disk Management.

Good luck. :)
 
#3
ok all set up but i ran into anouther problem. the raid is corectly set up to how i want it.(shows me in bios) 2 40gb hdd's st 1 80gh hdd but when i go to set up windows and i puch f6 to load raid driver nad then to the partition and format section. it shows both drives , shouldent it just show one 80gb?
 
S

silky62678

Guest
#4
Originally posted by canadian_divx
ok all set up but i ran into anouther problem. the raid is corectly set up to how i want it.(shows me in bios) 2 40gb hdd's st 1 80gh hdd but when i go to set up windows and i puch f6 to load raid driver nad then to the partition and format section. it shows both drives , shouldent it just show one 80gb?
I have the same mobo, did u have to use serial ata to set up the raid or 2 ide drives, if so, how did u do it?
 

Members online

No members online now.

Latest posts

Latest profile posts

Hello, is there anybody in there? Just nod if you can hear me ...
Xie
What a long strange trip it's been. =)

Forum statistics

Threads
61,961
Messages
673,239
Members
89,017
Latest member
bettyicrewsi