Monitor

Discussion in 'Windows Desktop Systems' started by brocher, Apr 24, 2005.

  1. brocher

    brocher Moderator

    Messages:
    516
    I have a CTX PR960F but for some reason it keeps going completely blurred, the only way to fix it is to switch it off and on again but it only last for a short while but you can imagine how frustrating this is? Does anyone know how this could be rectified?
     
  2. Lee

    Lee OSNN Proxy

    Fix the refresh rate to it's best level. If it's maximum is 75 then don't go above that.

    Thats a start.
     
  3. brocher

    brocher Moderator

    Messages:
    516
    The refresh rate is set to 100mhz as it has always been, i believe that it is has a fault within the unit it'self.
     
  4. Zedric

    Zedric NTFS Guru Folding Team

    Messages:
    4,006
    Location:
    Sweden
    Sounds like the monitor is on its last breath, yes.

    (This should be in General Hardware)
     
  5. brocher

    brocher Moderator

    Messages:
    516
    Well i took the monitor to bits ,Gave it a good clean out with a air compressor and blew out loads of dust and now it is working fine, i suppose that new flat screen will just have to wait.