The USB setup on one of our computors is driving me nuts.
When the computor is started up and the boot sequence and login are completed none of the usb devices are recognized.
I go to system, devicemanager and the little yellow "!" is hilighted on the "Via Rev 5 or later USB UNiversal Host Controller" under Universal Serial Bus Controllers. I can then disable the driver and then enable it and everything is fine. The driver loads and all other usb drivers load after that perfectly.
The usb ports are on the motherboard - Gigabyte 7VTXE+
- irq 21 not shared
- windows xp pro sp1
- disabled com2 and lpt1 as not needed
- disabled windows power off usb ports
- enabled usb 1 only on bios - Have tried all other settings
This wasn't much of a problem until we got a new printer that is USB only (Canon i950) . I can easily keep doing the above procedure but my wife finds things like this impossible.
I am hoping someone might have them same problem but searching the forums has not revealed something similar.
any ideas????
thanks
When the computor is started up and the boot sequence and login are completed none of the usb devices are recognized.
I go to system, devicemanager and the little yellow "!" is hilighted on the "Via Rev 5 or later USB UNiversal Host Controller" under Universal Serial Bus Controllers. I can then disable the driver and then enable it and everything is fine. The driver loads and all other usb drivers load after that perfectly.
The usb ports are on the motherboard - Gigabyte 7VTXE+
- irq 21 not shared
- windows xp pro sp1
- disabled com2 and lpt1 as not needed
- disabled windows power off usb ports
- enabled usb 1 only on bios - Have tried all other settings
This wasn't much of a problem until we got a new printer that is USB only (Canon i950) . I can easily keep doing the above procedure but my wife finds things like this impossible.
I am hoping someone might have them same problem but searching the forums has not revealed something similar.
any ideas????
thanks