brodyhooperquint
Jaws
- Joined
- 16 Jan 2004
- Messages
- 115
Hi, I've built my new Windows 7 system and set up two drives using an on-board controller - a RAID1 (2 DISK with OS on it) and a RAID 10 (4 DISK). I downloaded the Intel Rapid application and initialised both disks with it, 11 hours later, initialised and all fine. However when I go into Windows Disk Management it says the RAID 10 is not initialised? Does that mean I now need to initialise it again in here too and will it conflict in any way with the Intel Rapid application?
Any help would be greatly appreciated, thanks
Any help would be greatly appreciated, thanks
Last edited: