Originally posted by yoyo
I may be wrong here, not one of my specialties, but I think running an ATA 133 and an ATA 66 drive on the same controller will slow down the faster drive to also ATA 66. You may consider if you could change this.
Someone please correct me if I'm wrong.
Im using INTEL 485PEBT2 motherboard with Intel Application Accelerator and 120 G drive shows UDMA-5
30 G UDMA-2 ???
Controller Information
IDE Controller: Intel(R) 82801DB Ultra ATA Controller, ICH4
Storage Kit Build(s): 2.3.0.2164,
Storage Kit Installed: 2.3.0.2164
Driver Build: Intel Application Accelerator Driver
Driver Version: 2.3.0.2160
IDE Controller Tri-State: IDE Controller enabled
PIO Mode Support: 0 - 2 - 3 - 4
DMA SW Mode Support: 2
DMA MW Mode Support: 1 - 2
UDMA Mode Support: 0 - 1 - 2 - 3 - 4 - 5
Disk Timeout Value: Default
CDROM Timeout Value: Default
CD Audio Timeout Value: Default
UDMA on 80 conductor cable only: Default, Disabled
Flush Enable: Default, Disabled
Ping Pong Enable: Enabled
Primary Master: WDC WD1200JB-00CRA1
Model: WDC WD1200JB-00CRA1
Firmware: 17.07W17
Device Type: ATA - Fixed
PIO Mode Support: 0 - 1 - 2 - 3 - 4
DMA SW Mode Support: No Support
DMA MW Mode Support: 0 - 1 - 2
UDMA Mode Support: 0 - 1 - 2 - 3 - 4 - 5
LBA (28-bit maximum): 0x0DF94BB0
LBA (48-bit maximum): 0x00000DF94BB0
CHS: 3FFF x 0010 x 003F
CHS Sectors: 0x00FBFC10
Disk Size (28-bit maximum): 111.8 GB (120,034,123,776 bytes)
Disk Size: 111 GB (120,034,123,776 bytes)
Default Transfer Mode: UDMA-5
Current Transfer Mode: UDMA-5
Transfer Mode Limit: No Limit
Cable Type (Device): 80 Conductor
Cable Type (Host): 80 Conductor
PIO PPE: Enabled
UDMA Control Register: Ultra DMA Mode Enabled
UDMA Timing Register: CT = 3 CLK / RP = 16 CLK
Base Clock: Ultra DMA 100 Timings
Auto-Acoustic Management: Disabled
Dynamic APM on AC: Feature not supported by device.
Dynamic APM on Battery: Feature not supported by device.
Primary Slave: Maxtor 93073U4
Model: Maxtor 93073U4
Firmware: BAC51JJ0
Device Type: ATA - Fixed
PIO Mode Support: 0 - 1 - 2 - 3 - 4
DMA SW Mode Support: No Support
DMA MW Mode Support: 0 - 1 - 2
UDMA Mode Support: 0 - 1 - 2
LBA (28-bit maximum): 0x0393FDE0
LBA (48-bit maximum): 0x00000393FDE0
CHS: 3FFF x 0010 x 003F
CHS Sectors: 0x00FBFC10
Disk Size (28-bit maximum): 28.6 GB (30,735,581,184 bytes)
Disk Size: 28 GB (30,735,581,184 bytes)
Default Transfer Mode: DMA MW-2
Current Transfer Mode: UDMA-2
Transfer Mode Limit: No Limit
Cable Type (Device): 80 Conductor
Cable Type (Host): 40 Conductor
PIO PPE: Enabled
UDMA Control Register: Ultra DMA Mode Enabled
UDMA Timing Register: CT = 2 CLK / RP = 4 CLK
Base Clock: Ultra DMA 33 Timings
Auto-Acoustic Management: Custom, 0xC0
Dynamic APM on AC: Disabled
Dynamic APM on Battery: Disabled