Eproxus
Long gone and now back!
- Joined
- 18 Mar 2002
- Messages
- 158
All my IDE units work fine except that they are not found in the MBFastTrak133 startup section.
It just flashes "No Array is defined..."
And when pressing Ctrl+F to configure it says that my IDE devices are not on (i.e. no power or not connected).
I can boot into Windows if skipping MBFastTrak utility scanning.
How can I get rid of that scan, or set it up correctly? I don't want to run an RAID array...
Thanks in advance!
It just flashes "No Array is defined..."
And when pressing Ctrl+F to configure it says that my IDE devices are not on (i.e. no power or not connected).
I can boot into Windows if skipping MBFastTrak utility scanning.
How can I get rid of that scan, or set it up correctly? I don't want to run an RAID array...
Thanks in advance!