Overclocking...

Discussion in 'General Hardware' started by Artex, Nov 7, 2002.

  1. Artex

    Artex Guest

    Ok guys, I got a two parter

    1)If I increase the voltage to my 1400 Tbird, should I be able to push the FSB past 154? Its unlocked, but everytime I go to multiplier of 9 and push the bus past 154 its wont post up properly. Think a voltage increase would help. Also ram is not a limiting factor, its 2700.

    2)If I increase AGP voltage, would it help in ram overclocking on my 3dcard?

    Thanks guys
    Artex
     
  2. Ace123

    Ace123 Guest

    icreasing the coltage to both your agp and your cpu would be the way to go.. both are the limiting factor in overclocking. Just so you know those old tbirds dont like to go above 150 and usually overclocking them past this will resualt in a slower machine
     
  3. Artex

    Artex Guest

    I was hoping to break 12k 3dmarks, right now I'm stuck at 11387, was hoping some higher fsb would get me over hump. Thanks anyway.

    Artex